Removing Heater S-Type

Moderators:Aceman, ecosselynx

User avatar
sweller

Member
Posts:166
Joined:Wed Jul 22, 2009 4:02 pm
Removing Heater S-Type

Postby sweller » Sat Aug 08, 2009 8:33 pm

The heater flaps on my 1965 S type are stuck (in the hot position) - the small lever on the side of the heater is seized even with the control cable removed.

How is the heater attached to the bulkhead, how many screw/bolts? Anything to look out for?

I'm keen not damage the insulating material too much.

I'm slowly working through the niggling faults on this recently acquired car.

Thanks,

Simon

User avatar
sweller

Member
Posts:166
Joined:Wed Jul 22, 2009 4:02 pm

Postby sweller » Sun Dec 06, 2009 10:12 pm

I did this a month or so ago now - it was very easy.

Four screws and no need to damage the insulation. Once on the bench the flap freed up easily.

On examination I think I could have done it in situ. Plenty of penetrating fluid on the shaft ends, a brave heart and a pair of pliers on the 'free' end lever (the one that the cable isn't attached to) should have been enough.

Simon

User avatar
ollyw750

Member
Posts:7
Joined:Sun Feb 14, 2010 10:10 pm
Location:Oundle

Postby ollyw750 » Sun Feb 14, 2010 10:40 pm

I also did this a little while ago. When you remove the heater be careful to remove screw on the lower inboard corner of the heater unit, as it is not immediately obvious.

Regards,

Oliver



Who is online

Users browsing this forum: No registered users and 1 guest