Page 1 of 1

Diff whine

Posted: Sat Mar 19, 2022 6:11 pm
by timhenson
Hi

Hope everyone are well.

I know this topic has been discussed well back on this forum in 2017, but thought I would detail my issue in case someone can add more.

XK8 2005,48,000 miles car.
I have diff whine that starts at 40 MPH and is gone by 70 MPH (or cannot hear due to road noise).
Done oil change, black but no metal bits in oil.
I have noticable play at wheels when rocked at 12 / 6 oclock. I can feel some end float of the shafts going into the diff. Not sure how much, plan to measure with Dail Test indicator.

A previous very interesting post suggested tightening the large silver toothed nuts on the out puts to reduce the end float.

Questions please
1) What is the spec of the end float on the ouputs?
2) Does anyone have any other thgoughts?

Thanks in advance.

Kind Regards Tim Henson.

Re: Diff whine

Posted: Sat Mar 19, 2022 11:11 pm
by Astromorg
The given allowance for end float of the diff output shafts is 0 to 0.15 mm measured at the output flange.

Tightening that ring nut might affect the bearing preload, but I don't think it will affect the end-float unless there's less than no pre-load and that surely is unlikely?

Re: Diff whine

Posted: Sun Mar 20, 2022 9:53 am
by andypryce
I had the same on my 2006 X150. Replaced with a good used diff from Eurojag, sorted. I know people discuss the merits of using used parts, but given the age of these cars now to me it makes perfect sense.

Re: Diff whine

Posted: Wed Dec 07, 2022 7:17 pm
by timhenson
Hi

Thanks for these helpfull answers, sorry for not replying before, life got in the way

Tim