Page 1 of 1

Receiver-Dryer autopsy

Posted: Sat Nov 04, 2006 4:04 pm
by poprivet
http://www.jec-xjs-forum.org.uk/xjsbb2/ ... 37_1-3.jpg
A= Spring to keep dessicant pack compressed
B= Screen with glass fibre disc
C= Dessicant beads
D= Glass fibre wadding
E= Fine mesh screen
F= Locating disc
G= Copper tube, approx 2" long centrally located
H= Sight glass

Apart from the first 2" where the dessicant pack is located, the rest of the tube contains nothing (except refrigerant!)
Pop

Autopsy

Posted: Sat Nov 04, 2006 7:01 pm
by dhdove
Pop
Doesn't your lawn need cutting or something? 8)
DH Dove

Posted: Sat Nov 04, 2006 9:53 pm
by poprivet
:lol: The lawn will have to wait a bit, have you any idea how tricky it is to get one of these things back together again?
Pop

Receiver-Dryer autopsy

Posted: Thu Apr 19, 2007 1:55 pm
by ng4xjs
Blimy Pop

I'm having my R12 replaced next week with 134a and a new dryer.

Although I've had the system tested every couple of years over the 7/8 I've had the car it has never needed any new gas. This year started badly with an everso slightly suspect water valve and which when I replaced encouraged the system to work again. However I'm now committed to the change over.

Regards
Nick


Receiver-Dryer autopsy

Posted: Thu Apr 19, 2007 8:34 pm
by poprivet
Sounds expensive :cry: I've learnt a lot about the A/C over the last few months. Unfortunately, to do it legally and professionally the kit needed is a large financial investment. Added to the time involved in locating faults and then obtaining and replacing the parts I can now see why the firms have to charge what they do.
Still, once its done you can look forward to some great summer motoring. An xj-s needs its A/C. Some do without, but without a fair bit of work, the blowers will stay in re-circ mode and the re-heat battery will still operate.
Keep us updated!
Pop


Receiver-Dryer autopsy

Posted: Fri Apr 20, 2007 5:45 pm
by ptjs1
Nick,

Not that I know a lot about these things, but based on the previous posts on this subject, why are you not going for R413a as a straight replacement for your R12?

Paul




Receiver-Dryer autopsy

Posted: Sat Apr 21, 2007 2:14 pm
by dhdove
Pop
"without a fair bit of work, the blowers will stay in re-circ mode and the re-heat battery will still operate."
Can you explain please?
DH Dove


Receiver-Dryer autopsy

Posted: Sat Apr 21, 2007 6:08 pm
by poprivet
As I understand it, even when working normally, the air will be cooled below the dew point (condensation formed) to provide de-humidification and then re-heated to the required temperature.
If there isn't chilling available and the system is trying to cool, the Delanair III will go to full cooling mode which provides re-circ, not fresh air.
The heater water valve is normally open, vacuum closes it, so its impossible to manually shut it off, I doubt many shut completely even when the're supposed to.
If someone wanted to abandon the fridge side, it would be better to install a manual valve in the water pipework and somehow manually control the vacuum to the blower flaps. This is covered by the Gardner and Napoli mods on the MkII and no doubt with modification on the MkIII although I've not studied it lately as I have cooling :wink:
Pop


Receiver-Dryer autopsy

Posted: Sun Apr 22, 2007 1:45 am
by Jon
On my XJS I installed a switch which permitted me to have fresh air but without the air con running. As pop says, if the cooling requirement became too great, the delanair would go into recirc mode, thus defeating the object. So I added another switch which disables the recirc solenoid 8)