Nostalgia XK120 build
Posted: Sat Jan 17, 2015 4:29 pm
Hi all,
I am in the final stages of building a Nostalgia XK120 replica. One of the things I found during the build was that there was not a lot of information on the web about these cars or the build, so I thought I would share my experiences with you all.
The story starts in late 2011 when I purchased a 3.6 litre, manual XJS to use as a donor. The Nostalgia kit is engineered for a series 3 XJ6 donor, but I wanted the benefits of a more modern engine, and the XJS shares enough parts with a series 3 that it works as a donor car.
After driving around in the XJS for a while, getting wet legs from the rotten wings the battery eventually died in the bad weather of early 2012. That was my excuse to start stripping the car.
I needed to keep the body shell rolling so it could be removed from my garage. I spent a while trying to work out how to do this and also keep the suspension, steering and brake components which are used for the XK120. In the end I came to an agreement with a Jaguar dismantler. They would collect the rolling body shell, then they would remove the front and rear suspension assemblies and I would go to collect them later on. Apart from the time it took them to remove the sub-frames this worked well.
Once the XJS had gone I had the space to collect the chassis kit from Nostalgia.
I am in the final stages of building a Nostalgia XK120 replica. One of the things I found during the build was that there was not a lot of information on the web about these cars or the build, so I thought I would share my experiences with you all.
The story starts in late 2011 when I purchased a 3.6 litre, manual XJS to use as a donor. The Nostalgia kit is engineered for a series 3 XJ6 donor, but I wanted the benefits of a more modern engine, and the XJS shares enough parts with a series 3 that it works as a donor car.
After driving around in the XJS for a while, getting wet legs from the rotten wings the battery eventually died in the bad weather of early 2012. That was my excuse to start stripping the car.
I needed to keep the body shell rolling so it could be removed from my garage. I spent a while trying to work out how to do this and also keep the suspension, steering and brake components which are used for the XK120. In the end I came to an agreement with a Jaguar dismantler. They would collect the rolling body shell, then they would remove the front and rear suspension assemblies and I would go to collect them later on. Apart from the time it took them to remove the sub-frames this worked well.
Once the XJS had gone I had the space to collect the chassis kit from Nostalgia.