Interior light fuse

Moderators:robv12, xj40_register, Popsjag

steve_m
Posts:1441
Joined:Mon Mar 02, 2009 11:46 am
Location:Wiltshire
Interior light fuse

Postby steve_m » Fri May 03, 2019 12:43 pm

So, the X Type let me down again and I had to take the XJR6 to work.
Getting in the car at 0455 I realised that all the interior lights were out although the roof console buttons were still lit.
I didn't have time to mess about so set off anyway.
is it likely to be a sticking door switch or a fuse?
If the latter where is the fuse located?
Ta.

Jonathan T

Member
Posts:8
Joined:Thu Jun 26, 2008 9:48 pm

Re: Interior light fuse

Postby Jonathan T » Tue Aug 23, 2022 12:58 pm

Steve, I hope after three years since posting your query, the interior light problem with your XJR6 has been solved. I have an interior light fuse problem so thought it easier to pick up this thread rather than start a new one.
Two days ago all the interior lights in my 1995 Daimler 6 failed and I have found that fuse F8 in the RHS heelbox had blown. I replaced the fuse but it blew immediately. Any ideas what could be the likely cause or where to start looking for the source of the problem would be appreciated.

steve_m
Posts:1441
Joined:Mon Mar 02, 2009 11:46 am
Location:Wiltshire

Re: Interior light fuse

Postby steve_m » Tue Aug 23, 2022 1:32 pm

I sorted it by selling the car!
I can't remember what I did but it might be worth checking the sun visor wiring if lamps are fitted.

Jonathan T

Member
Posts:8
Joined:Thu Jun 26, 2008 9:48 pm

Re: Interior light fuse

Postby Jonathan T » Tue Aug 23, 2022 1:38 pm

Thanks Steve.

Jonathan T

Member
Posts:8
Joined:Thu Jun 26, 2008 9:48 pm

Re: Interior light fuse

Postby Jonathan T » Tue Aug 08, 2023 5:31 pm

Nearly a year after my last post on the subject of the interior light circuit fusing I have now found the source of the problem, or at least Stewart Hunt at XJ Engineering in Bentley has found and fixed it. As suspected the wiring going into the nearside (LHS) sun visor has crimped and the connection needed to be made good. It is fine now. Whilst investigating the problem it was also found that the wires around the RHS boot lid hinge had crimped as well and the boot light had failed as had the boot press button switch. Reconnecting these solved these problems as well. All in all - a good result.


Who is online

Users browsing this forum: No registered users and 1 guest