Page 1 of 1

Distributor Rebuild

Posted: Sat May 19, 2018 12:35 pm
by Tintin
I have just refitted the distributor to my 4.2 litre S1 following a rebuild by the Distributor Doctor and the engine is transformed. I am particularly pleased with the smoothness of idle, and pick-up.

We tend to pay a lot of attention to points, plugs, timing and carburettors but forget that distributors wear and springs weaken over time (at least I do!). The rebuild was worth every penny and Martin Jay at the Distributor Doctor was very efficient and helpful.

Just thought I would share.

Robbie

Re: Distributor Rebuild

Posted: Sat May 19, 2018 3:20 pm
by piman
Hello Robbie,

good to hear. I've long thought when people say they replace their distributor with such as a 123 and the car runs much better. If the original, as yours was, is not working right it's no surprise.

Alec

Re: Distributor Rebuild

Posted: Sun May 27, 2018 10:21 am
by RichardSEL
An equivalent 123 (includes new cap and leads too) is £300 from SC Parts -- I'd like to stay OEM with my 4.2L (ex-420G) engined Mk IX (my last restore) but fear there's just too much wear there.

The Owen Sedanca's only done 23k built on a '72MY series 1 chassis so there's no point changing that.

Could you give an indication of how much Distributor Doctor costs for a series 1 distributor recon?

Re: Distributor Rebuild

Posted: Sun May 27, 2018 9:12 pm
by piman
Hello Richard,

my Triumph (six cylinder) rebuild by the doctor with the addition of one or two consumable spares was about £150, but about three years ago.

Alec

Re: Distributor Rebuild

Posted: Mon May 28, 2018 9:32 am
by RichardSEL
An equivalent 123 (includes new cap and leads too) <snip>
Does not include leads

Re: Distributor Rebuild

Posted: Mon May 28, 2018 9:34 am
by RichardSEL
Hello Richard, my Triumph (six cylinder) rebuild by the doctor with the addition of one or two consumable spares was about £150, but about three years ago. Alec
#

Thanks Alec. I'll give 'em a bell and report back -- specialist craft skills available like these are worth reporting in forum :arrow:

Re: Distributor Rebuild

Posted: Fri Jan 04, 2019 4:53 pm
by Laughton
Hello folks,

I'm a long-time member from Canada, but only recently started viewing here. It looks like a great resource.

I've swapped a S3 dizzy, with coil and amp into a S1. It's straight swap, and eliminates the possible dwell irregularities that come with shaft slop. These used bits may cost less than a new one.

Good luck,

Rob

Re: Distributor Rebuild

Posted: Fri Jan 04, 2019 5:07 pm
by mike020150
Many years ago, I bought a brand new series 3 electronic distributor at Spares Day for £15. I think I sold it a decade later for £30. Those were the days eh? :D Mike.