www.jec.org.uk

Hello,

I get an error after programming the ride height using SDD with 156 SW version and Mongoose Pro after

• clearing the faults (new sensors and one damper) with no codes logged (green ticked)

• the Car having the correct ride height within +5 millimeters; and

• being on a flat surface.

The Car was taken for a test drive and behaved as it should.

Has anyone got any ideas on why this may be the case, could it be the compressor not performing as it should in a 2003 model with 150K mileage?

Best regards Robert

If the compressor has covered 150,000 miles, it has done remarkably well and therefore has to be a prime suspect. Mike.