Page 1 of 1

Kenlowe 2 Stage Fan Controller

Posted: Sun Aug 26, 2012 2:32 pm
by rcmcewen
Anyone got experience of using the kenlowe KLM2455 two stage controller with two fans.
My Series 2 E Type has one fitted but it doesn't work :x and I can't see how to test it.
The sensor is pushed through the fins of the radiator core. The whole lot is encapsulated so it's impossible to put a meter on the connections. I have power at the main fan input terminals. If I connect the green wire to 12v nothing happens (with the ignition on) although this is meant to be the manual override.
Any views would be appreciated.
Roger McEwen

Re: Kenlowe 2 Stage Fan Controller

Posted: Thu Sep 06, 2012 10:37 am
by oz5986
Hi Roger, check fuse and fuse holder, sometimes a normal one will melt as the current consumption is very high. has it got the adjustable temp control? if so you turn it right round and the fan should come on. if not you need to test the relay connections. Should have a four pin switching relay or 5 pin changeover relay.Terminals on relay are numbered 30, 85, 86, 87 and if 5 pin theres 87a There are different ways to wire this up but this and if your not confident i would advise an auto electrician. Otherwise as i have been one for about 20years feel free to call me on 07577 004005. Regards Oz

Re: Kenlowe 2 Stage Fan Controller

Posted: Fri Sep 07, 2012 10:50 am
by rcmcewen
Hi Oz,
Thanks for the info. Didn't realise that the relays were plug in. I had 12v on the output with the fan disconnected, but 0V on the output when connected :!: Unplugged the relays, cleaned and greased the terminals, reassembled and now works fine. :D However I am now going to wire up the manual override so that I can easily test the system regularly.
Regards
Roger