Hi, can you just swap SLS complete units for standard earlier units?
I have a 1991 xj6 and i can't see any pipes going to the rear shocks so i thinking mine have allready been converted, but my dampers are shot so would i just by a set of pre SLS dampers for a 2.9/3.6 xj40?
jamie.
SLS swap?
Moderators:robv12, xj40_register, Popsjag
If your car has SLS you will see pipes to the rear shocks
The swap is easy, as you say buy two standard shocks, remove the old SLS shock and springs, after releasing the fluid feed pipe, drain the fliud, trace the pipe work back under the car and remove then use the blanking nipple from one shock to blank off the feed from the pump, remove the SLS sender from the r/h lower rear wishbone, tape up the electrical connectors, dismantle the old units on the bench, rebuild with new shocks and spacers and refit, test drive
The swap is easy, as you say buy two standard shocks, remove the old SLS shock and springs, after releasing the fluid feed pipe, drain the fliud, trace the pipe work back under the car and remove then use the blanking nipple from one shock to blank off the feed from the pump, remove the SLS sender from the r/h lower rear wishbone, tape up the electrical connectors, dismantle the old units on the bench, rebuild with new shocks and spacers and refit, test drive
Who is online
Users browsing this forum: No registered users and 2 guests
