Page 1 of 1

Removing Heater S-Type

Posted: Sat Aug 08, 2009 8:33 pm
by sweller
The heater flaps on my 1965 S type are stuck (in the hot position) - the small lever on the side of the heater is seized even with the control cable removed.

How is the heater attached to the bulkhead, how many screw/bolts? Anything to look out for?

I'm keen not damage the insulating material too much.

I'm slowly working through the niggling faults on this recently acquired car.

Thanks,

Simon

Posted: Sun Dec 06, 2009 10:12 pm
by sweller
I did this a month or so ago now - it was very easy.

Four screws and no need to damage the insulation. Once on the bench the flap freed up easily.

On examination I think I could have done it in situ. Plenty of penetrating fluid on the shaft ends, a brave heart and a pair of pliers on the 'free' end lever (the one that the cable isn't attached to) should have been enough.

Simon

Posted: Sun Feb 14, 2010 10:40 pm
by ollyw750
I also did this a little while ago. When you remove the heater be careful to remove screw on the lower inboard corner of the heater unit, as it is not immediately obvious.

Regards,

Oliver