Can anyone suggest a cause for the 50 amp fuse in my Mk2 blowing? Recently, I replaced it on the road and it blew again within a mile or two - as I disengaged overdrive. As well as all gauges and heater fan, the brake lights, indicators and wipers go through this fuse so I am anxious to trace the cause. Richard
What were the weather conditions? Day or night? "Within a mile or two" could be making discovery worrying as it's an intermittant. Yet that could also help you.
Leave on tickover for five to ten with all electricals switched off. If you've no blow by the time full warm up occurs and then some you can start adding in the loads.
You've identified what circuits are fed via this switch so let's assume that the overdrive solenoid is not the culprit for the moment. And that your faulty circuit is one you've mentioned. Switch in one by one (for gauges I only had a Mk I many years back but seem to recall gauge lights only came on with sidelights (?), brake lights (probable as together with side lights they're available for water leaks to spoil), then indicators (ditto), heater fan, wipers.
Repeat when driving. If you can get this far with full loads (had a Mk IX that was glove box light -- they've only got four fuses

Then use your overdrive a few times. If there fault still doesn't show itself then it's time for waggling
looms around those circuits.
You might like to clean the fuse holder and the fuse ends. I had a Citroen CX that had 1ΒΌ" glass fuses fitted to spade holders.
The holder cover had been missing for years so each of the fuse ends and the spades were deeply corroded. Rust being an insulator and the current flow high the Watts of heat generated at each end of the fuse was such that the fuse wire would melt... nothing whatever to do with a bad circuit
