Many thanx for the reply~managed to get it working by cleaning contacts and opening the ECU and checking. Also had the remote key checked and all Ok. Would have replied earlier but have had difficulty signing on to the Forum~it seems you have to change Yr password every time. Rgds.

Hello Folks, The remote key stopped working so sent it away for refurb and rcvd it back and still it does'nt work. Looks like the problem lies elsewhere and would welcome any advice on how to proceed from members who have encountered this problem particularly where is the transponder located in the ...

Hello Folks, I need a bit more legroom as i'm 6ft 2" as does my son who is 6ft4". I have adjusted the drivers seat back as far as possible but it comes up against the rear seat. If one removes the rear seat is it possible to get the drivers seat to move further back? I suppose the answer might be tr...

Hello Folks, Have boot light failure on XJS V12 91 Facelift. Have traced the wiring to the connector in the boot lid which appears to go to the boot latch mechanism. Does anyone have experience of replacing this unit and where the boot light switch is located? Thanx in anticipation. Charlie. 2022080...

Hello Folks,
Would any member be prepared to lend me (for a consideration) the cam lock bars for V8? Rgds. Charlie.

Thanx Andy will follow up..Rgds.

Hello Folks,
Could anyone advise if i can hire the V8 cam locking bars and crank pulley bar puller from the club? Thanx in anticipation.

Further on this could anyone advise if i can hire the V8 cam locking bars and bolts and puller bar to remove the front crank pulley. Thanx. Rgds.

Hello Folks,
Have to remove the front gear cover on my 4.0L and wondered if i can remove the front crank pulley bolt with a windy? Have done this before on other cars without problems. Regards.. Charlie.

Thanx for the prompt response. I looked for another ring but they all have i/d = 82mm. My shaft o/d is 80.76mm so thort i would raise the issue as i cant be the only one with this problem. There probably is another ring with an i/d of 80mm possibly for another make of car but i dont have the time to...

Hello Folks, Had to install a new rear reluctor ring for ABS and found that the ring i purchased which was listed as compatible was too large. Ring i/d=81.70 shaft o/d 80.76. So it just slides over. Has anyone encountered this issue and hopefully resolved it? What i need is a smaller ring of course....

Hello Folks, Experienced a loss of power on my 91 V12 5.3 and the fault code FF13 is flagged. Occasionally the engine will cut out but so far has always restarted. Has anyone experienced this fault and can advise of possible causes and investigative procedure. Thanx in anticipation. Charlie.

Hi Andy,
Would appreciate if you could email the manual. Thanx in anticipation. Rgds. Charlie.

Hello Folks,
Could anyone advise how to remove the front passenger window switch? Dont have a manual. Rgds.

Hello Folks, Could anyone advise how to remove the front passenger window switch? It stopped working but the window works from the drivers side switch. Oddly it occasionally works and will open the window "one touch" but it wont go up again and i have to close it from the drivers side. Any advice ap...